Please Select your custom set using the pictures above. Choose the # of panel set you would like - Please note some may be out of stock.
Please Note: We will need your serial # before shipping for fitment - Please put in the comments or email us, if we do not hear from you we will email you
Give the Akai MPC LIVE II MK2 the classic look with these wood side panels with tilt setup made from real walnut. Walnut is the same wood used in hight end Bentley and Rolls Royce dashboards!
Description:
Complete 2 piece real walnut Akai MPC Live wood panel kit along with 2 support bars, screws, removal tool, and rubber feet for traction on slick areas. This kit installs very easily and can be taken on and off very quickly with the removable tool that fits in the bottom of hte panel. These also have nicely shaped vent holes on the side to provide the MPC Live II unit with ventilation. Please note you must be very careful when removing due to the very sensitive nature of the MPC Live II paint coating. The tilt angle is approximately 15 degrees.
Included Parts: (ASSYs)
- Left Side Panel (Walnut)
- Right Side Panel (Walnut)
- 2 - Metal Support Bars
- 4 - Fastening Screws
- 4 - Rubber Feet
- 1 - Allen Hex Install Tool
This Part will fit:
Akai MPC Live II (MK2)
Please Note:
These wooden parts may have slight variations in color and due to the type of Walnut wood that is used some sides can look a bit different than each other. Being that they are wood, you must be careful to treat them properly. Please watch the install video shown below to insure that you are installing the panels properly. Since the panels are wood you may see the slight variations and small flaws in the wood. If you have any questions about this please email us. Does not include white skin that is pictured.
VERY IMPORTANT: As you may already know, Akai used a very soft paint/material on the outside of the MPC Live, if you remove and reinstall the unit often it may start to rub the paint finish off the edges. If you have any questions about this please email us. MPCstuff is not responsible for any wear you may add to your MPC finish.
