Wood Side Panel Tilt Stand - Akai MPC Live - Walnut Portable -
Give the Akai MPC LIVE the classic look with these wood side panels with tilt setup made from real walnut. Walnut is the same wood used in hight end Bentley and Rolls Royce dashboards!
Description:
Complete 2 piece real walnut Akai MPC Live wood panel kit along with 2 support tubes and rubber feet for traction on slick areas. This kit installs very easily and can be taken on and off very quickly or you can slide your LIVE right out of the back without taking apart. These also have nicely shaped vent holes on the side to provide the MPC Live unit with ventilation. Please note you must be very careful when removing due to the very sensitive nature of the MPC Live paint coating. The tilt angle is approximately 15 degrees.
Included Parts: (ASSYs)
- Left Side Panel (Walnut)
- Right Side Panel (Walnut)
- 2 - Metal Support Rods
This Part will fit:
Akai MPC Live
Please Note:
These wooden parts may have slight variations in color and due to the type of Walnut wood that is used some sides can look a bit different than each other. Being that they are wood, you must be careful to treat them properly. Please watch the install video shown below to insure that you are installing the panels properly. Since the panels are wood you may see the slight variations and small flaws in the wood. If you have any questions about this please email us. Does not include white skin that is pictured.
VERY IMPORTANT: As you may already know, Akai used a very soft paint/material on the outside of the MPC Live, if you remove and reinstall the unit often it may start to rub the paint finish off the edges. If you have any questions about this please email us. MPCstuff is not responsible for any wear you may add to your MPC finish.
